TTI 340A-C0

No reviews

Sale price$757.00
Sold out


1-5/8" x 1-3/4" STEP HEADERS, 3.0" COLLECTORS


  • 1-5/8" O.D. primary tubes steps up to 1-3/4" secondary tubes with 3" 3-bolt collectors

  • Recommended for 320-575 horsepower

  • Above the steering center link design (under chassis) offers maximum header to ground clearance

  • "Step" design provides low-end response and top-end horsepower gain

  • Full length header design for proven power gain

  • Constructed of 16 gauge mild steel tubing

  • Mandrel bent on sophisticated computer controlled bending machines for precise fit and uninterrupted exhaust flow. The mandrel bending process maintains a constant inside diameter of the tube for a smoother finish with no restriction of flow and no crimping of the tubes.

  • 3/8" thick laser-cut header flanges contoured for a leak free fit

  • 3/8" thick laser-cut 3-bolt collector flanges

  • Removal of the torsion bars not required

  • Easy spark-plug access

  • Coupled with a TTi Exhaust Systems these headers become even more efficient!

  • Due to the numerous engine configurations and suspension combinations, TTi cannot ensure headers and exhaust to fit all combinations, however, we have done our best to accommodate both factory and aftermarket component combinations.  e.g. Engine blocks, cylinder heads, starters, valve covers, etc.

     Raw Steel (Bare)

    Mild steel is very susceptible to rust, it must be high-temp painted or protected and sealed in order to prevent rust from
    damaging tubing. A light coat of oil or grease will aid in rust control. (This note does not apply to Stainless Steel Headers and
    Exhaust Systems). No warranty offered other than to be free from defects at the time of purchase prior to installation only.
    Under no circumstance will we replace, repair or refund headers purchased raw. High-temp paint is recommended upon
    receiving headers.

You may also like

Recently viewed