HUG SMC1326AL 318 WHIPLASH CAM 109º LSA+5 WHIPLASH SERIES FLAT TAPPET HYDRAULIC CAMSHAFT $292.43
 Whiplash Flat tappet hydraulic small block "LA" camshaft.
Hughes "real" Chrysler cam
WARNING: Our Whiplash cam is designed for basically stock, low compression engines. This cam will run on pump gas in a 318 with 8.6:1 or less compression and iron heads. If your compression is higher than this you may need to use a higher octane race fuel. Your vacuum should be in the 9"-11" range using this cam.
(Figures calculated using stock stroke & compression at 750' altitude.)
Basic guidelines (These are not absolutes, just guidelines to help you get close on a cam choice)
Use: Street and some strip
Idle: Like it wants to bite your head off! Very aggressive
Vacuum: Low
Converter: Stock or a mild stall
Rear gear: Stock or up to 3.55
Benefits: Tons of low end torque and a super aggressive idle that scares Mustangs, Camaros and rice burners from even thinking about messing with you.
To hear this cam in action check out the customer videos and testimonial at this link. CLICK HERE
TECH NOTES: Click Here to see our article on Whiplash Cams
The OEM Distributors have terrible advance curves. Many go as far as 50+° advance which will cause major damage and have very poor acceleration. When you order a Whiplash cam ask for the special whiplash advance curve specs or we can supply you with a new Pertronix distributor (P/N PRT 7141700) and we will custom curve it for no extra charge.
Pertronix distributors all contain their own electronics, no need to rely on old Mopar orange or chrome box electronics.
We also recommend our distributor shaft collar (P/N HUG 22041) to limit the travel of the intermediate shaft reducing spark scatter and increasing power.
Be sure to check out our NO FLAT CAM GUARANTEE!
CLICK HERE BEFORE ORDERING
  
Related Parts:
Lifters: Standard performance use HUG 5001 High performance use HUG 5003
Valve Springs: For 1.5 or 1.6 ratio rockers use HUG 1110P
Valve Locks: For 11/32" stem use HUG 1302 For 3/8" stem use HUG 1304
Retainers: For 11/32" stem use HUG 1202 For 3/8" stem use HUG 1252
Rocker Arm Kits: On standard style heads use 1.5 ratio HUG 15023 For 1.6 ratio use HUG 15063
Break-in Oil: 5W30 JGP 01806 or 15W50 JGP 00106
Cam Key: HUG 7542
Cam bolt & washer: HUG 7011
Timing Chain & Gear Set: 3 key way use HUG 6440 or for a 7 keyway use HUG 6442
| 
;void(0);)